Geothermal Heat Pump Piping Diagram

June 10th 2011, Geothermal Heat Pump, Khader Khan, 0 comments

GeothermalHomeowners primarily install geothermal heat pumps which draw heat from the ground during the winter and from the indoor air during the summer for heating and cooling their homes. For water heating, you can add a desuperheater to a geothermal heat pump system. A desuperheater is a small, auxiliary heat exchanger that uses superheated gases from the heat pump's compressor to heat water. This hot water then circulates through a pipe to the home's storage water heater tank.

The condensing units, having more auxilliary equipment are more complex than the atmospheric exhaust units, and the bigger sizes can take twice as long to construct and install. Condensing plants with a capacity of 55 to 60 MWe are very common, but plants of 110 MWe have also been constructed and installed.' (source: Dickson/ Fanelli, 2006)

With the convenience of designing the loop layout of the Ground Source Heat Pumps i.e. the loop design can be horizontal or vertical or even immersed in water. Ground Source Heat pumps and the piping loops can be installed after studying the property in greater detail relating to the property size and structure and the soil present on it.

Geothermal electrical power refers to the use of all-natural resources of warmth inside the Earth to make heat or electricity. Currently, most geothermal strength is produced utilizing steam or hot drinking water from underground. Geothermal energy generation produces few emissions and the electrical power resource is constantly offered.

Continue